(2) Press the address key
the program.
6.1.3 INSERTING INSTRUCTION WORD
Insert G01 instruction before address X40 in the steps below:
Locate the cursor at X40, type G01 and then press the Insert key
6.1.4 DELETING INSTRUCTION WORD
To delete instruction word G01:
1) Locate the cursor at G01
2) Press the Delete key
shown below
CNC 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
and then the
Program
Data=
Program
Data=
to delete G01 (the instruction word that current cursor points at), as
key, and the cursor returns to the start of
, as shown below:
Manual mode
Manual mode
32