Adtech ADT-CNC4220 User Manual page 32

The operation follows:
1) Input Z14.
2) Press the
address Z. If you press the
Z14, and alarms.
◆To return to the start of the program
Method 1
In editing mode and program display page, press the Reset key
the start of the program.
Method 2: Searching
(a) Select the editing mode;
(b) Press the Program key
(c) Type address key
is number 5);
(d) Press the
Method 3: scanning
(1) Select the editing mode to enter the program display interface;
Program
Data=
key and the system starts searching downwards; after that, the cursor locates
key to search upwards, the system can't find instruction word
Program
Data=
to enter the program display interface;
and number key
key and the cursor returns to the start of the program
CNC 4 2 2 0 M a c hi ne Too l Op e ra t ion an d Te st
Manual mode
Not searched!
Editing mode
and the cursor returns to
(the current program
31