Table of Contents
Advertisement
Startup and Basic Operation
Power
When power is applied by plugging in the included power supply, the encoder runs a series
of self-tests that blink the front panel Power LED and all other indicators. The encoder then
boots the NAV operating system. It can take approximately 45 seconds for self-test and
system startup to complete. When the process is complete, the Power LED lights steadily.
NOTE: The encoder is NOT operational until the boot process is complete (the Power
Pairing Devices Manually
Manually pair devices as follows:
1.
2.
3.
4.
5.
NOTE: Units can be paired manually via the ID button, but they cannot be unpaired
Operation
After the encoder, all decoders, and their connected devices are fully booted up and
operational (the Power LED on each unit is lit steadily) and the devices are paired, the
system is fully operational. If any problems are encountered, ensure all cables are routed
and connected properly.
System operation with a NAVigator
Your NAV system must include an Extron NAVigator, a system manager that configures and
controls the AV streaming system. The NAVigator allows you to make changes to multiple
endpoints in the system from a central location, simplifying operations such as making ties
or bulk configuration.
The base version of the NAVigator can support up to 16 endpoints by default, but if a
LinkLicense is installed, support can be expanded to up to 240 endpoints, depending on
the LinkLicense.
See the NAVigator User Guide, available at
LED is lit steadily).
Use a Tweeker or other small screwdriver to press and hold the
encoder front panel ID button for approximately 3 seconds, until the
ID LED blinks. The encoder enters pairing mode.
One at a time, use a Tweeker or other small screwdriver to press and
hold the decoder front panel ID button for approximately 3 seconds,
until the ID LED blinks. Release the ID button. The decoder is now
paired to the encoder.
Repeat step 2 for each decoder.
Use a Tweeker or other small screwdriver to press and release the encoder front panel
ID button. The encoder exits pairing mode.
Repeat steps 1 through 4 to pair decoders to other encoders.
manually. To unpair units, use the embedded HTML pages of either the decoder (see
the applicable decoder user guide) or of the NAVigator (see the NAVigator User Guide).
The applicable user guides are available at www.extron.com.
www.extron.com
NAV E 511 Encoder • Installation and Basic Operation
ID
NA
NA
N A
N
NAV E 511
A
A
for details.
14
Advertisement
Table of Contents
