Table of Contents
Advertisement
1 1
Figure 43.
3.
4.
You are now ready to begin entering commands.
Open the DataViewer Help File from the toolbar for more information on the program.
Sending commands using a TCP/IP connection
1.
2.
3.
4.
2 2
Communications Dialogs
Select the startup options:
a.
If RS-232 is selected (
1
b.
If TCP/IP is selected (
2
password, if necessary.
c.
If USB is selected (
), choose Extron USB Device in the drop-down window.
3
NOTE: To automatically connect to the SME 211, select Connect on
Click OK to connect to the SME 211 and start using the program.
Configure the network settings of a control PC so that it can be connected to the
same network as the SME 211. Use an RJ-45 cable to connect the control PC to the
network.
Start the DataViewer program (see
page) and follow the steps to connect to the SME 211 via TCP/IP.
On the Communication Setup window (see figure 43):
a.
Select the TCP/IP tab.
b.
Enter the IP address of the SME 211 into the Hostname/IP Address field.
c.
In the Telnet Port field, enter the port number for the connection.
NOTE: The default telnet port to send SIS commands to the SME 211 is
port 23.
Click OK. The Communication Setup dialog closes.
), configure the port settings.
), configure the IP address and Telnet port. Enter a
Start the DataViewer program
SME 211 • Reference Information
3 3
Extron USB Device
Startup.
on the previous
89
Advertisement
Table of Contents
