System Settings - Extron electronics SME 211 User Manual

System Settings

Controls within seven of the ten panels in the System Settings page within
Configuration are essential during initial setup of the unit. The three other panels
contain features that are used infrequently for updating the unit, restoring a configuration, or
limiting access to front panel controls. A user must be logged in as an administrator to see
or change these settings.
To open this page, click the Configuration tab at the top of the SME 211 embedded
web pages and then click the System Settings tab on the second tier of tabs.
Figure 32.
The System Settings page opens.
Figure 33.
The panels are:
Unit Identification — Set the system (unit) name and a descriptive name
1
for its location. This is also the read-only location of the model name, description,
part number, serial number, firmware version, overall unit temperature, remote panel
connection, remote panel firmware, and enabled feature licenses.
Date and Time — Set the date, time, time zone, and settings for syncing with one or
2
more NTP (network time protocol) servers.
Networking — Set the IP address, subnet mask, gateway, and DNS server, as well as
3
the port information for a variety of port types, or enable or disable SNMP.
USB Port Power — Choose which USB port (front or rear) has the higher current
4
limit.
Serial — Set the baud rate and protocol for the rear panel remote control serial port.
5
Firmware and License Loader — Firmware and LinkLicense uploads can be
6
initiated here.
Backup and Restore — Current SME or IP configuration settings can be backed up,
7
or a previously saved configuration file can be restored to the unit from this panel.
Executive Mode — Enable or disable front panel lock-out to limit access to the
8
controls and functions of the SME.
NOTE: See the SME 211 Embedded Web Pages Help File for additional information.
Configuration Tab, System Settings Subtab
System Settings Page
SME 211 • Web-Based User Interface 47