Table of Contents
Advertisement
Installation
This section provides information on:
•
•
•
Mounting the SME 211
The SME 211 is housed in a 1U high, half rack width, two-piece metal enclosure that can
sit on a table with the provided rubber feet or can be mounted using the attached rack
mounts. Select a suitable mounting location, (see
then choose an appropriate mounting option.
•
•
Rear Panel Overview
100-240V
0.7A
USB
50-60 Hz
A
B
Figure 3.
100-240 VAC IEC connector for power input
A
USB type A receptacle for external storage
B
device
(see page 9)
HDMI input
(see page 10)
C
3.5 mm, 5-pole captive screw connector for
D
analog stereo audio input
Power Connection
A
Mounting the SME 211
Rear Panel Overview
SME 211 Rear Panel Reset
Disconnect power from all external devices before connecting to the SME 211.
Do not apply power to the SME before connecting external devices.
INPUTS
OUTPUT
AUDIO
L
LINE
R
HDMI
HDMI
C
D
E
SME 211 Rear Panel
(see page 10)
100-240 VAC power input — Connect the provided IEC cord. Verify the front panel
buttons and LCD illuminate (see
NOTE: Make all external device connections to the SME before applying power.
Mounting the SME 211
REMOTE
RS-232
RESET
Tx
Rx
G
F
G
HDMI preview output
E
3.5 mm, 3-pole captive screw connector for
F
Simple Instruction Set (SIS) control over RS-232
(see page 9)
Reset button and LED
G
RJ-45 Ethernet port for LAN connection
H
page 9)
Front Panel Features
on page 13).
on page 86)
SME 211
LAN
H
(see page 10)
(see page 9)
(see
SME 211 • Introduction
8
Advertisement
Table of Contents
