Table of Contents
Advertisement
G
Startup and Basic Operation
Power
When power is applied, the decoder runs a series of self-tests that blink the front panel
Power LED and all other indicators. The decoder then boots the NAV operating system. It
can take approximately 45 seconds for self-test and system startup to complete. When the
process is complete, the Power LED lights steadily.
NOTE: The decoder is NOT operational until the boot process is complete (the Power
Pairing Devices Manually
Pair devices as follows:
1.
2.
3.
4.
5.
NOTE: Units can be paired manually via the ID button, but they cannot be unpaired
Operation
After the encoder, all decoders, and their connected devices are fully booted up and
operational (the Power LED on each unit is lit steadily) and the devices are paired, the
system is fully operational. If any problems are encountered, ensure all cables are routed
and connected properly.
ID button and LED (see
figure 8
pressed, identifies the decoder to other network units and to the embedded HTML
pages (see "Pairing Devices Manually"). The LED blinks when the decoder is in pairing
mode and lights steadily when it is paired or device identification is selected from the
decoder or NAVigator HTML page.
NOTE: The ID button triggers the status on-screen display (OSD), which shows on
the HDMI Output port (see
LED is lit steadily).
Use a Tweeker or other small screwdriver to press and hold the
encoder front panel ID button for approximately 3 seconds, until the
ID LED blinks. The encoder enters pairing mode.
One at a time, use a Tweeker or other small screwdriver to press and
hold the decoder front panel ID button for approximately 3 seconds,
until the ID LED blinks. Release the ID button. The decoder is now
paired to the encoder.
Repeat step 2 for each decoder.
Use a Tweeker or other small screwdriver to press and release the encoder front panel
ID button. The encoder exits pairing mode.
Repeat steps 1 through 4 to pair decoders to other encoders.
manually. To unpair units, use the embedded HTML pages (see
page 37) or a connected NAVigator (see the NAVigator User Guide, available at
www.extron.com).
on page 12) — The recessed ID button, when
on page 7).
B
NAV SD 511 Scaling Decoder • Installation
ID
NA
NAV SD 511
A
A
A
A
V
V
V
V
V
Ties Page
on
14
Advertisement
Table of Contents
