Table of Contents
Advertisement
Image Settings
The controls within the Image Settings page within the Configuration tab provide
options to configure video input sampling and sizing, set up overscanning of SMPTE input
signals, and adjust picture controls (brightness, contrast, and similar). This page also allows
the user to save or recall input presets. A user must be logged in as an administrator to see
or change these settings.
To open this page, click the Configuration tab at the top of the SME 211 embedded
web pages and then click the Image Settings tab on the second tier of tabs.
The Image Settings page opens.
Figure 22.
This page has the following panels:
Input Signal Sampling — This is a read-only panel, which displays the Horizontal
1
Start, Vertical Start, Total Lines, Total Pixels, Active Pixels, and
Active Lines.
Picture Controls — Alter the quality of the image by changing brightness and contrast,
2
or select Auto-Image, Auto-Image & Fill, or Auto-Image & Follow buttons.
Overscan — Set the amount (0, 2.5%, or 5%) of picture enlargement applied to the
3
HDMI video signal for any SMPTE standard input.
Input Presets — Save up to 128 presets or recall one of those presets, each with a
4
combination of signal type, signal sampling, picture controls, and audio gain settings.
Image Settings Page
SME 211 • Web-Based User Interface
31
Advertisement
Table of Contents
