Table of Contents
Advertisement
Input Connections
The SME 211 has one HDMI digital video and audio input and one 3.5 mm, 5-pole captive
screw connector for analog stereo audio input.
C
D
Output Connection
E
SME 211 Rear Panel Reset
The Reset button on the rear panel of the SME 211 (see
returns the SME 211 to various default conditions. There are three unit reset modes
(numbered 1, 4, and 5) that are initiated from the rear panel reset button. To select different
reset modes, use a pointed stylus or small screwdriver to press and hold the Reset button
while the SME 211 is powered or press and hold the Reset button while applying power to
the SME 211.
HDMI input — Connect an HDMI (or DVI with suitable adapter) source device to input
(see
figure
3,
on page 8).
C
Analog audio input — Connect a balanced or unbalanced stereo line level audio
device to this 5-pole, 3.5 mm captive screw connector. Analog audio can be selected
for output with the HDMI input instead of the embedded audio. Wire the connector as
shown below.
Tip
Ring
Sleeves
Tip
Ring
Figure 4.
Audio Input Captive Screw Connector Wiring
Balanced Stereo Input
ATTENTION:
•
Do not tin the wires. Tinned wires are not as secure in the captive screw
connector and could pull out.
•
Ne pas étamer les câbles. Les câbles étamés ne sont pas aussi bien fixés dans
les connecteurs des à vis captives et pourraient sortir.
•
The length of the exposed wires in the stripping process is important. The ideal
length is 3/16 inch (5 mm). If longer, the exposed wires may touch, causing a
short circuit between them. If shorter, the wires can be easily pulled out even if
tightly fastened by the captive screws.
•
La longueur des câbles exposés est importante lorsque l'on entreprend de les
dénuder. La longueur idéale est de 5 mm (3/16 inches). S'ils sont trop longs,
les câbles exposés pourraient se toucher et provoquer un court-circuit. S'ils
sont trop courts, ils peuvent être tirés facilement, même s'ils sont correctement
serrés par les borniers à vis.
HDMI output — Connect an HDMI (or DVI with a suitable adapter) display device to
this HDMI output connector for easy size and position setup and to access the internal
web browser.
Tip
Sleeve
Tip
Sleeve
Unbalanced Stereo Input
figure
3,
G
SME 211 • Introduction
Do not tin
the wires!
on page 8)
10
Advertisement
Table of Contents
