Installation; Rear Panel Connections - Extron electronics DSC 301 HD User Manual

Installation

This section provides a description of the DSC 301 HD rear panel connectors and
instructions for cabling.
ATTENTION:

Rear Panel Connections

This section describes how to connect cables to a DSC 301 HD scaler.
DSC 301 HD
POWER
POWER
1 2
1 2
12V
12V
1.5A MAX
1.5A MAX
VIDEO RGB/R-Y,Y,B-Y
VIDEO RGB/R-Y,Y,B-Y
G A
Figure 1.
Inputs and Outputs
A
B
C
D
A
B
• Installation and service must be performed by authorized personnel only.
• L'installation et l'entretien doivent être effectués uniquement par un électricien
qualifié.
INPUTS
INPUTS
3
3
1
1
HDMI
HDMI
B C
DSC 301 HD Rear Panel Features
Input 1 (BNC connector)
Input 2 (15-pin HD connector)
Input 3 (HDMI connector)
Audio inputs 1-3
Input 1 — Connect a composite video input to this BNC connector.
Input 2 — Connect an input to this configurable analog 15-pin HD (VGA) connector
for RGBHV, HD component video, or YUVi signals.
The analog input port can be configured to accept RGB (RGBHV, RGBs) or
component video (bi- or tri-level) signals. The default setting is for RGB. The
on the next page shows the pinouts for each format type on the 15-pin HD (VGA)
connector. The 15-pin HD supports EDID emulation.
DSC 301 HD
DSC 301 HD
2 3
2 3
AUDIO
AUDIO
D
Control and Power
HDMI output
E
Remote RS-232 control port
F
Power input
G
DSC 301 HD • Installation
REMOTE
REMOTE
RS-232
RS-232
Tx Rx G
OUTPUT
Tx Rx G
OUTPUT
E F
table
5