Table of Contents
Advertisement
NAV 10E 401 D and NAV 10E 201 D • Setup Guide (Continued)
Indicators and buttons
Visible LEDs
(LEDs that are always visible)
E
•
Power (PWR) — Indicates power and startup status.
Blinking — The unit is receiving power and is booting up.
Lit steadily — The unit is receiving power and is operational.
•
HDMI — The encoder is detecting an HDMI input.
•
HDCP — The HDMI signal is HDCP encrypted.
•
Stream (STRM)— Indicates the output status of the AV stream.
Lit steadily – The encoder is actively streaming a NAV output consisting of video, audio, or both.
Blinking – The encoder is actively streaming a NAV output, but network errors are present.
Hidden buttons and LEDs
F
•
Reset button and LED — This recessed button and LED initiate and display three modes of reset (see the NAV 10E 401 D and
NAV 10E 201 D User Guide, available at
•
ID button and LED — The recessed ID button identifies the encoder when pressed. The LED blinks when the encoder is in
pairing mode (see
•
NAV 10G LEDs — Indicate the status of the network connection.
Link LED — Lit steadily indicates that a network link is established.
Act LED — Blinking indicates network traffic. The blink rate corresponds to activity.
Rear Panel Connectors
NAV 10G port
Connects to a LAN on which one or more
A
—
decoders also reside for streaming and control.
B
CONTROL RS-232/IR port —
a modulated IR signal, or both to this 3.5 mm, 5-pole
direct insertion connector for bidirectional RS-232 and IR
communication with connected remote controlled devices
using an Extron control system (see
page 8 to wire the connector).
Power
C
connector — Connect the included external 12 VDC power
supply into this 2-pole direct insertion connector for local power
Power connector
(see
Installation
Step 1: Prepare the Installation Site
ATTENTION:
Installation and service must be performed by authorized personnel only.
•
L'installation et l'entretien doivent être effectués par le personnel autorisé uniquement.
•
Extron recommends installing the encoder into a grounded, UL Listed electrical junction box.
•
Extron recommande d'installer le encoder dans une boîte de dérivation électrique mis à la terre, certifiée UL.
•
If the encoder will be installed into fine furniture, it is best to hire a licenced, bonded craftsperson to cut the access
•
hole and perform the physical installation so the surface will not be damaged.
S'il est prévu d'installer le encoder dans du beau mobilier, il est préférable de faire appel à un artisan autorisé et
•
qualifié pour couper le trou d'accès et réaliser l'installation de telle façon que la surface ne soit pas endommagée.
Follow all national and local building and electrical codes that apply to the installation site.
•
Respectez tous les codes électriques et du bâtiment, nationaux et locaux, qui s'appliquent au site de l'installation.
•
2
figure 1
(see
on page 1)
—
(features that are visible only when the faceplate is removed) —
www.extron.com
Pairing devices on front panel
Connect a serial RS-232 signal,
connector
Control
on page 8 to wire the connector).
, for details).
on page 7 for details).
on
Figure 2.
NAV 10E 401 D and NAV 10E 201 D Rear
Panel Features
B
B B
C
C C
+
Tx Rx
G
S G
POWER
RS-232
IR
12V
CONTROL
2.0A MAX
A
A A
Advertisement
Table of Contents
