Table of Contents
Advertisement
Installation
This section details the installation of the DAC 102, including:
•
•
Installation Overview
ATTENTION:
Follow these steps to install and set up the DAC 102 for operation:
1.
2.
3.
4.
5.
6.
7.
Installation Overview
Rear Panel Features
•
The installation must always be in accordance with the applicable provisions of
National Electrical Code ANSI/NFPA 70, article 725 and the Canadian Electrical
Code part 1, section 16. The power supply shall not be permanently fixed to
building structure or similar structure.
Cette installation doit toujours être conforme aux dispositions applicables du Code
•
américain de l'électricité (National Electrical Code) ANSI/NFPA 70, article 725, et
du Code canadien de l'électricité, partie 1, section 16. La source d'alimentation ne
devra pas être fi xée de façon permanente à une structure de bâtiment ou à une
structure similaire.
•
This product is intended to be powered by a UL Listed power source marked
"Class 2" or "LPS", output rated 5Vdc or from a USB port on a Listed device.
•
Ce produit doit être alimenté par une source d'alimentation certifi ée UL de classe
2 ou LPS, avec une tension nominale 5 Vcc ou depuis un port USB d'un appareil
certifi é.
Turn off all equipment and disconnect from the power source.
If desired, mount the decoder (see
Connect source devices via the TOSLINK or S/PDIF RCA inputs.
Connect the output of the DAC 102 to an audio amplifier or audio processor (see
figure 2,
on page 4).
B
Connect a volume controller (such as a compatible VCM and MLC analog volume
controller) to the 3-pole, 3.5 mm blue captive screw connector (
control.
Connect power to the decoder by connecting the included USB-A to USB mini-B
cable to the rear female USB mini-B port (
decoder to be powered from a 5 V USB power source.
To configure the unit, connect your computer to the POWER/CONFIG USB mini-B port
(
). Use the Product Configuration Software (PCS) or Simple Instruction Set (SIS) to
A
adjust settings.
Power on the products connected downstream from the DAC 102.
Equipment Mounting
on page 19).
C
). The mini USB port allows the audio
A
DAC 102 • Installation
) for remote volume
3
Advertisement
Table of Contents
