Table of Contents
Advertisement
Installation
This section gives the steps for installing the DVC RGB-HD A. It also provides a description
of the rear panel connectors and instructions for cabling. Topics include:
•
•
•
•
•
•
Installation Overview
ATTENTION:
Follow these steps to install and set up the DVC RGB-HD A :
1.
2.
3.
4.
5.
6.
7.
8.
Installation Overview
Front and Rear Panel Features
Wiring the Power Connector
Securing the HDMI Connector Using the LockIt Cable Lacing Bracket
Connecting for USB Control
EDID Minder
•
Installation and service must be performed by authorized personnel only.
•
L'installation et l'entretien doivent être effectués par le personnel autorisé
uniquement.
Disconnect power from the converter and ensure that all other devices that will be
connected to it are powered off.
(Optional) Mount the unit in a rack or to furniture (see Mounting, beginning on
page 32).
Connect the input. Connect an RGBHV source to the front panel VGA input
connector (see
figure
2,
B
(Optional) Connect the audio input. Connect analog audio to the 3.5 mm TRS jack on
the front panel (see
figure
2,
Connect the digital output. Connect an HDMI sink to the rear panel HDMI output
connector (see
figure
3,
B
Connect a control device. Connect a computer or control system to the rear panel
figure
USB Config port (see
commands or the PCS Configuration Software.
Connect a 12 VDC power supply to the 2-pole captive screw power connector (see
figure
3,
).
A
NOTE: The 12 VDC power supply is not included, but can be ordered at
www.extron.com.
Configure the DVC RGB-HD A as needed, using SIS commands (see the
Configuration and Control
the program help file).
, on the next page).
).
C
, on page 5).
3,
) to configure and control the converter via SIS
C
section, beginning on page 11) or the PCS software (see
DVC RGB-HD A • Installation
Remote
3
Advertisement
Table of Contents
