Table of Contents
Advertisement
Clean the Z-sensors in the registration output module with system tray
Clean the Z-sensors in the registration output module with system tray
There are two registration output modules: with or without a system tray. This topic describes the
cleaning of Z-sensors in the registration output module with a system tray. When the registration
output module has no system tray, see
without system tray on page
When the Z-sensors in the registration output module are polluted, an action required window
appears on the control panel.
[321] Location of the registration output module with system tray
Before you begin
You need cleaning cloths to clean the Z-sensors (Alphawipe pads Texwipe TX1004).
Procedure
Action
1
Open the front door of the registration output module.
2
Use the green handle to open the paper guide.
3
Use the green handle to open and hold the Z-
sensor unit.
314
Chapter 12 - Maintain the printer
Clean the Z-sensors in the registration output module
312.
4
Advertisement
Table of Contents
