Table of Contents
Advertisement
Learn about stacking behaviour
Learn about stacking behaviour
One or two high capacity stackers collect the prints and automatically eject a stack of prints.
Overview of the high capacity stacker on page
(
Below you find three stack and eject scenarios (A, B, C) for transaction and document print jobs
that you configure on the VarioPrint i-series.
A. Use the full capacity of the stack trays
1
[92] Transaction print job
1
[93] Document print job
1. The stack tray of the first high capacity stacker collects the prints of the first job until the
maximum stack height has been reached.
2. The eject tray of the first high capacity stacker ejects the first stack of job 1.
3. The stack tray of the first high capacity stacker collects the remaining prints of the first job
and first prints of the second job.
4. The stack tray of the second high capacity stacker collects the remaining prints of the second
job, because the linking of output s is enabled.
How to configure this scenario?
Settings Editor
1. Define a stack height. (
ing in the high capacity stacker on page
2. Set 100% as minimum filling rate. (
default stacking in the high capacity stack-
er on page
84
Chapter 5 - Job media handling
2
2
Define default stack-
68)
30)
3
3
Control panel
1. Specify in the workflow profile that a stack
68)
eject occurs when the tray is full and ena-
Define
ble the linking of output trays. (
workflow profile on page
4
4
Choose a
114)
Advertisement
Table of Contents
