Table of Contents
Advertisement
Action
4
Place a ream of media on a flat surface. The
direction of the arrow on the label indicates
the preferred side for printing. For two-sided
printing this side indicates the front side
which is printed first.
5
Fold out the short sides of the package ma-
terial.
6
Open the package along the glue strip.
7
Remove the top sheet of the stack and in-
spect the four sides of the stack. Remove the
sheets that have imperfections: bends, folds,
cuts, rips, crumpled edges, wavy edges,
tight edges.
After you finish
1. Store remaining media in the original packaging or other moisture proof material. Use the
original package orientation and do not turn over the stack.
2. When the printer is in sleep mode you can leave the media in the paper trays. However, when
the printer is shut down, you must remove the media from the paper trays.
3. A difference of the relative humidity of the media packaging and the paper module can cause
excessive sentry rejection. Follow the help instructions when needed. (
the sentry tray on page
IMPORTANT
When you use a knife to open a
ream be careful not to touch the
media.
344)
Unpack the media
Many sheets arrive in
Chapter 5 - Job media handling
89
Advertisement
Table of Contents
