Table of Contents
Advertisement
Read tolerance levels for the media family calibration
The evaluation of media family calibration results are based on set tolerance levels.
Colour evaluation methods use metrics to decide if printed colours are close enough to their
reference colours or not. (
validation metrics on page
takes place. The level specifies where a calculated difference is still acceptable and where not. A
tolerance level is also expressed by a △(Delta) value.
You cannot change or add tolerance levels for the media family calibration.
Tolerance levels for measurement accuracy
To decide if measurements are considered as accurate or not, PRISMAsync Print Server uses
tolerance levels for chart measurements.
Tolerance levels for the measured paper white and primary colours
To decide if paper white and primary colours are reproduced correctly or not, PRISMAsync Print
Server uses tolerance levels.
Read a tolerance level
1. Open the Settings Editor and go to: [Colour]→[Colour validation & verification].
[256] Colour menu
2. Select the required tolerance level.
Learn about colour differences on page
375) A tolerance level or threshold level is set before the evaluation
Read tolerance levels for the media family calibration
Overview of colour
261,
Chapter 10 - Print what you expect
243
Advertisement
Table of Contents
