Table of Contents
Advertisement
Load media into the paper module
Action
7
Slowly turn the knob in clockwise direction until
the side sliders touch the stack without damag-
ing it.
8
Squeeze the green handle of the front slider to
move the trailer-edge sliders carefully against
the stack without damaging it.
9
Unpack the following ream of media or take ap-
proximately 500 sheets (80 g/m² / 20 lb bond).
Unpack the media on page
(
Paper tray 1 and 2 can hold one ream (approxi-
mately 500 sheets (80 g/m² / 20 lb bond)). Paper
tray 3 and 4 can hold three reams.
Carefully put the new stack on the already loa-
ded stack without adjusting the sliders.
10
11 Gently push the paper tray back until it clicks in-
to place.
82
Chapter 5 - Job media handling
88)
IMPORTANT
Ensure the loaded media stack does not exceed the loading limit mark on the
back slider.
Then, the loaded media stack is maximum 63 mm / 2.48" (paper tray 1 and 2) or
181 mm / 7.13" (paper tray 3 and 4).
Advertisement
Table of Contents
