Table of Contents
Advertisement
AckTrig
DisTrigSense
Local Command Set 4-48
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
configuring not only the general settings of the trigger inputs
and outputs, but also the Racal-Dana Trigger Interface Chip
(TIC) counter and tick timers. The trigger configuration
commands are TrigAsstConf, TrigExtConf,
TrigCntrConf, TrigTickConf, and
TrigToREQT is a special function for the 1260-00C to map
trigger interrupt sources to SRQ on the GPIB so VXI trigger
protocols can be completely controlled from an external GPIB
controller.
Purpose:
Acknowledge the specified TTL/ECL or external
(GPIO) trigger.
Query
Syntax:
AckTrig <line>
where the value of <line> corresponds to the
trigger line to acknowledge:
Value
0 to 7
8 to 9
40 to 49
Response:
Program response: 0
Console response:
Trigger acknowledged (line = <line
text>).<CRLF>
where the meaning of <line text> corresponds
to the value of <line> as follows:
Value of <line>
0 to 7
8 to 9
40 to 49
Example:
Acknowledge a trigger interrupt for TTL line 4.
AckTrig 4
Purpose:
Disable the sensing of the specified TTL/ECL
trigger line, counter, or tick timer that was enabled
by EnaTrigSense.
1260-00C User Manual
TrigToREQT.
Trigger Line
TTL trigger lines 0 to 7
ECL trigger lines 0 to 1
External source/destination (GPIO 0 to 9)
Value of <line text>
TTL <line>
ECL (<line> - 8)
GPIO (<line> - 40)
Advertisement
Table of Contents
