Table of Contents
Advertisement
1260-00C User Manual
Table 3-12, Non-Slot 0 Message-Based Device Operation Switch and Jumper Settings
Jumper/Switch
Switch S15
Switch S22
Switch S23
Switch S24
Logical Address
Non-Slot 0 Model Code
Servant Area Size
Non-Slot 0 Message-
Based Device Operation
Front Panel LED
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
appropriate Servant area size using the non-volatile
configuration mode. If the logical address is set to FFh, the
1260-00C will participate in dynamic configuration.
Otherwise, the 1260-00C is a static configuration device.
d.
Set the various switches, jumpers and non-volatile
configurations as shown in Table 3-12.
Position
OFF
OFF
OFF
OFF
See Chapter 5.
See Chapter 5.
See Chapter 5.
At start-up, a 1260-00C configured as a Non-Slot 0
Message-Based device performs its self-tests. It then waits until it
receives its Device Grant and Begin Normal Operation Word Serial
commands. The RM grants any logical addresses to the
1260-00C that reside within its Servant area. When it responds to
the Begin Normal Operation command, the 1260-00C enters its
normal mode of operation
The 1260-00C indicates the progress of its self-test with the
Function
If S15 is ON, the 1260-00C
sources CLK10 at the front
panel EXT CLK connector.
VXI BTO disabled.
Bus arbiter and SYSCLK
disabled. CLK10 receiving
form backplane.
MODID pulled down.
Logical address is not equal
to 0. Set in non-volatile
configuration or by using DIP
switch SW1.
Model code is set to the Non-
Slot 0 value. Set in non-
volatile configuration.
Set appropriate Servant area
size. Set in non-volatile
configuration.
.
Operation 3-21
Advertisement
Table of Contents
