Table of Contents
Advertisement
Local Command Set 4-58
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
configure:
Value
40 to 49
40
41
42
43
44 to 49
and <mode> specifies the configuration mode,
where
Bit
0
1
2
3
All other values are reserved for future expansion.
Response:
Program response: 0
Console response:
External connection (GPIO)
configuration complete (extline =
<extline text>, mode = <mode>).<CRLF>
where the meaning of <extline text>
corresponds to the value of <extline> as follows:
Value of <extline>
40 to 49
Example 1 : Configure external line 41 (front panel Out) to not
be used as feedback and left tri-stated for use as a
mapped output via MapTrigTrig.
TrigExtConf 41, 0
Example 2 : Configure external line 40 (front panel In) to not be
1260-00C User Manual
Trigger Line
External source/destination
(GPIO 0 to 9)
Front panel In (connector 1)
Front panel Out (connector 2)
ECL bypass from front panel
EXTCLK
Hardware-dependent GPIOs 4 to
9
Configuration Modes
1 = Feed back any line mapped as
input into the cross-point switch
0 = Drive input to external (GPIO) pin
1 = Assert input (regardless of
feedback)
0 = Leave input unconfigured
1 = If assertion selected, assert low
0 = If assertion selected, assert high
1 = Invert external input (not
feedback)
0 = Pass external input unchanged
Value of <extline text>
GPIO (<extline> - 40)
Advertisement
Table of Contents
