Table of Contents
Advertisement
The 1260-00C
Non-Volatile
Configuration
Main Menu
Read In Non-Volatile
Non-Volatile Configuration 5-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
b. In 488-VXI runtime system mode, enter NV configuration
mode through the CONF command.
c. In VXI pROBE mode (on development modules only), enter
NV configuration mode through the CONF command.
The non-volatile configuration commands must be executed from
the RS-232 port.
The EEPROM is connected to the microprocessor via a I
bus. It takes five to ten seconds to write the contents of the
memory. The 1260-00C creates a copy of the contents of the
EEPROM in RAM, which can be quickly edited. When the editing
is complete, the entire contents of the RAM copy is written back to
the EEPROM.
Note that some changes (such as the pSOS parameters) do not
take effect until the system is restarted. This is accomplished by
the pROBE commands IN or BO , by resetting the system, or by
cycling the system power.
When entering the NV configuration mode, the 1260-00C displays
the menu shown in Figure 5-1.
1260 VXI Non-Volatile Configuration Main Menu
=================================================
1.
Read In Non-Volatile Configuration
2.
Print Configuration Information
3.
Change Configuration Information
4.
Set Configuration to Factory Settings
5.
Write Back (Save) Changes
6.
Quit Configuration
Choice (1-6):
Figure 5-1, The 1260-00C Non-Volatile Configuration Main
From the main menu, select the NV memory editing function and
enter its number at the prompt. The effect of selecting each item
is described below.
Read In Non-Volatile Configuration reads the contents of
1260-00C User Manual
Menu
2
C serial
Advertisement
Table of Contents
