System Start-Up Message Printing; Slot 0 Resource Manager Configuration; Figure 3-9, Vxi System Start-Up Message Switch Settings; Table 3-7, Slot 0 Resource Manager Operation Switch And Jumper Settings - Racal Instruments 1260-00C User Manual

1260-00C User Manual
System Start-Up
Message Printing

Figure 3-9, VXI System Start-Up Message Switch Settings

Slot 0 Resource
Manager
Configuration

Table 3-7, Slot 0 Resource Manager Operation Switch and Jumper Settings

Jumper/Switch
Switches S9 and S15
Switch S22
Switch S23
Switch S24
Logical Address
Slot 0 Model Code
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The serial port start-up printout enable switch S21 controls
whether or not VXI system start-up messages are printed to the
serial port, as shown in Figure 3-9. The factory default
configuration disables this function
To configure the 1260-00C for Slot 0 Resource Manager
operation, enable the VXIbus Slot 0 functions, and set the logical
address to 0, as shown in Table 3-7.
Position
See Table 3-8. CLK10 routing options.
ON VXI BTO enabled.
ON Bus arbiter and SYSCLK enabled. CLK10
sourcing for backplane is enabled.
ON MODID pulled up
See Chapter 5. Logical address is 0. Set in non-volatile
configuration or use the DIP switch.
See Chapter 5. Model code is set to the Slot 0 value. Set in
non-volatile configuration.
.
Function
Operation 3-13