Table of Contents
Advertisement
Number of pSOS
Processes
Number of pSOS
Message Exchanges
Number of pSOS
Message Buffers
Console
VXI Interrupt Level to
Handler Logical Address
Non-Volatile Configuration 5-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
etc., are allocated from this region. The first 64 kilobytes (0 to
FFFFh) of any size onboard RAM configuration are reserved for
use by Racal-Dana. Allocation of the rest can be made for Region
1, Code Instruments, or a device-dependent use. Region 1 always
starts at local address 10000h. The minimum size is 60000h. The
maximum size is the amount of RAM minus 10000h.
This parameter is used to configure the maximum allowable
number of pSOS processes. The 1260-00C requires a minimum
of 16 processes. The factory setting is 32.
This parameter is used to configure the maximum allowable
number of pSOS message exchanges. The 1260-00C requires a
minimum of 16 message exchanges. The factory setting is 32.
This parameter is used to configure the maximum allowable
number of pSOS message buffers. The 1260-00C requires a
minimum of 100h message buffers. The factory setting is 180h.
This parameter is used to set the 1260-00C RS-232 local
command console to default to enabled or disabled. The local
command ConsoleEna is used to change the setting at runtime
This is a table of logical addresses the Resource Manager can use
during resource management of the VXI interrupt lines. If an
interrupter is hard-configured (not a VXI programmable
interrupter), place the logical address of the interrupt handler
device in the corresponding level. If an interrupt handler is
hard-configured (not a VXI programmable handler), place its
logical address in the corresponding level to avoid conflicts with
other programmable handlers, and also to permit the Resource
Manager to assign programmable interrupters to the correct levels.
If all interrupters and interrupt handlers are programmable, keep
the value of FFh for all entries in the table.
As part of the hardware capabilities on the 1260-00C, there are
three VXI programmable interrupt handlers. They can be
assigned dynamically by the RAM or statically according to the
contents of the non-volatile memory.
1260-00C User Manual
.
Advertisement
Table of Contents
