Keep Designation For Internal Relays, Shift Registers, Counters, And Data Registers - IDEC FT1A Series User Manual

Keep Designation for Internal Relays, Shift Registers, Counters, and Data Registers

The statuses of internal relays and shift register bits are usually cleared at startup. It is also possible to designate all or a block of
consecutive internal relays or shift register bits as "keep" types. Counter current values and data register values are usually
maintained at powerup. It is also possible to designate all or a block of consecutive counters and data registers as "clear" types.
When the SmartAXIS is stopped, these statuses and values are maintained. When the SmartAXIS is reset by turning on a
designated reset input, these statues and values are cleared despite the settings in the Configure Keep/Clear Settings dialog box
shown below. The keep/clear settings in this dialog box are not maintained when restarting the SmartAXIS.
Since these settings relate to the user program, the user program must be downloaded to the SmartAXIS after changing any of
these settings.
Programming WindLDR
From the WindLDR menu bar, select Configuration > Memory Backup.
1.
The Function Area Settings dialog box for Configure Keep/Clear Settings appears.
Click the buttons under Internal Relay, Shift Register, Counter, and Data Register to clear all, keep all, or keep/clear specified
2.
range as required.
Resets all Function Area Settings
values to defaults.
S AXIS P /L U
MART RO ITE
' M FT9Y-B1378
SER S ANUAL
5: S F
PECIAL UNCTIONS
5-7