IDEC FT1A Series User Manual page 181

Writing/Clearing TP (Timer Preset Values) and CP (Counter Preset Values) in the User Program
Writing TP (Timer Preset Values) and CP (Counter Preset Values)
Even if you modify TP (Timer Preset Values) and CP (Counter Preset Values) with Device Monitor mode, those changes are not
written to the user program in the ROM. To write the changed preset values to the ROM, you must stop the SmartAXIS and
confirm the changes. When you modify TP (Timer Preset Values) and CP (Counter Preset Values) and attempt to leave Device
Monitor mode, the message below is displayed.
Timer/counter preset
values are changed.
Press the (ESC) button or the
1.
When the SmartAXIS is running
Running
T/C is changed
2012/OCT/10/WED
13:30:40
When TP (timer preset values) and CP (counter preset values) differ from the device values in the ROM, T/C is changed is
displayed on the standard screen.
When the SmartAXIS is running, put it to Stop mode. For the steps to stop the SmartAXIS, see "Switching run/stop" on page 6-7.
On the standard screen, press the
2.
Stopped
T/C is changed
2012/OCT/10/WED
13:30:40
The system menu is displayed.
Select Edit Program with the
3.
Run
Edit Program
External Memory
Configurations
4. Select T/C Preset Values and press the
T/C Preset Values
Select Confirm with the
5.
T/C Change Status:
T/C is changed
Clear
Confirm
The changed preset values are written to the user program in the ROM.
(OK) button to display the standard screen.
When the SmartAXIS is stopped
Stopped
T/C is changed
2012/OCT/10/WED
13:30:40
(ESC) + (OK) buttons.
(up) and (down) buttons and press the
(OK) button.
(up) and (down) buttons and press the
S AXIS P /L
MART RO ITE
(OK) button.
U ' M FT9Y-B1378
SER S ANUAL
6: HMI F
(OK) button.
UNCTION
6-17