IDEC FT1A Series User Manual page 176

6: HMI F
UNCTION
Notes:
When the slave number is modified from the system menu, the value in the slave number type (constant/special data register) configured
•
with WindLDR is modified. The slave number type cannot be changed from the system menu.
If the slave number type configured with WindLDR is Constant, when the slave number is modified from the system menu and the
•
button is pressed, the modified slave number is reflected in the function area settings for the user program. If Special Data Register, the
values of D8027 and D8028 are modified. (The modification is not reflected in the function area settings for the user program.)
The values of D8027 and D8028 return to the default values when the battery backup dies.
•
The slave number configuration range differs according to the communication mode (maintenance communication/Modbus RTU slave).
•
If a value outside the configuration range is set, the following message is displayed. Press the
to the configuration screen, and then set the correct slave number again.
Port 2:
Out of valid range
0
For maintenance communication, see "Maintenance Communication via Expansion Communication Port" on page 9-3, and for Modbus RTU
•
slaves, see "Modbus Communication via RS-232C/RS-485" on page 11-1.
Configuring the Network Settings
When the SmartAXIS (24/ 40/ 48-I/O type) is stopped, you can configure the netwrok settings.
These cannot be configured while the SmartAXIS is running.
On the standard screen, press the
1.
Stopped
2012/OCT/10/WED
13:30:40
The system menu is displayed.
Select Configurations with the
2.
Run
Edit Program
External Memory
Configurations
3. Select Function with the
Function
Clock
Menu Languages
Backlight
Select Communications with the
4.
Communications
Message Settings
Select Network Settings with the
5.
Slave Number
Network Settings
The network settings screen is displayed.
For example, change the IP address to 192. 168. 1. 6.
6-12
(ESC) + (OK) buttons.
(up) and (down) buttons and press the
(up) and (down) buttons and press the
(up) and (down) buttons and press the
(up) and (down) buttons and press the
S AXIS P /L U
MART RO ITE
(OK) button.
' M FT9Y-B1378
SER S ANUAL
(ESC) button or the button to return
(OK) button.
(OK) button.
(OK) button.