Installation Overview - Labcyte Echo 520 User Manual

2.2

Installation overview

The Labcyte Echo liquid handler is installed by Labcyte field engineers. The
following is a brief overview of the hardware and software installation
steps they perform:
1. Unpack the Echo liquid handler and place it in the area that meets the
2. Connect the Echo liquid handler to AC power, air pressure, vacuum
3. Fill the coupling fluid bottle and prime the coupling fluid circuit.
4. Perform a basic functional check of the Echo liquid handler.
5. Perform the Site Acceptance Test (SAT) process (optional).
6. Change the Echo IP address, if a different IP address is required by your
7. Install the Echo software onto the customer-supplied PC
8. Connect the client PC to the Echo liquid handler and verify
Figure 2.2 Installed system
minimum operating space requirement.
pressure, surge tank, coupling fluid bottle, and the coupling fluid chiller.
system administrator.
(client workstation).
communications.
Ethernet cable
(cross-over)
Client PC
Echo liquid handler
Bench
Floor
Compressed air line
Vacuum line
Chiller
fluid lines
Surge tank
Chiller
Installation and Relocation 2-5