Uponor Smatrix Move PRO Installation And Operation Manual page 66

EN
I-TIME
In this menu the I-time for the mixing valve regulation
CZ
is set.
To set the I-time:
DE
1. Select I-time.
2. Press the navigation wheel to confirm selection.
DK
3. Set the value.
Stand Alone Control/Smatrix Base PRO:
Default: 50 seconds
EE
Setting range: 5 – 300 seconds, 1 second increments
Domestic Hot Water:
ES
Default: 18 seconds
Setting range: 5 – 300 seconds, 1 second increments
4. Confirm the setting by pressing the navigation
FI
wheel again.
ACTUATOR RUNNING TIME
FR
In this menu the actuator running time for the mixing
valve regulation is set.
HR
To set the actuator running time:
1. Select Actuator running time.
HU
2. Press the navigation wheel to confirm selection.
3. Set the value.
Stand Alone Control/Smatrix Base PRO:
IT
Default: 60 seconds
Setting range: 0 – 500 seconds, 1 second increments
LT
Domestic Hot Water:
Default: 60 seconds
Setting range: 0 – 300 seconds, 1 second increments
LV
4. Confirm the setting by pressing the navigation
wheel again.
NL
NO
PL
PT
RO
RU
SE
SK
6 6
Seasonal Shut Off
This menu enables access to seasonal shut off settings
in the zone.
This menu is only shown if Zone Setup is set to Stand
Alone Control or Smatrix Base PRO.
MENU TREE*
Seasonal Shut Off
* Parts of the menu tree may only be visible in the Move PRO
controller depending on its current configuration.
PUMP STOP
In this menu a function to stop the circulation pump,
when requirements are met, is enabled.
This menu is only shown if Zone Setup is set to Stand
Alone Control.
To enable the function:
1. Select Pump Stop.
2. Press the navigation wheel to confirm selection.
3. Select Enable.
Default: Disable
Setting range: Disable/Enable
4. Confirm the setting by pressing the navigation
wheel again.
U P O N O R S M AT R I X M O V E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
Pump Stop
Valve Close
Shut Off Outdoor Temp.
T. Outdoor Setpoint
T. Outdoor Delay
Shut Off Indoor Temp.
T. Indoor Delay