QUICK GUIDE Contents Uponor Smatrix Base PRO components Uponor Smatrix Base PRO components .......2 An Uponor Smatrix Base PRO system may be a System example ..............2 combination of the following components: Safety instructions ............3 • Uponor Smatrix Base PRO Controller X-147 Controller ................3...
Controller be done before registering a system device. N O T E ! arning The Uponor system uses 50 Hz, 230 V AC Up to 16 controllers can be registered to an power. In case of emergency, immediately interface. disconnect the power.
QUICK GUIDE Register thermostat and/or system device Register a system device (I-147 etc) to a controller N O T E ! To register room thermostats and system devices (interface At least one thermostat must be registered before etc.) to the controller: registering a system device.
QUICK GUIDE Register multiple controllers Unregister all channels Up to 16 controllers can be registered to an interface. When one or more channels are inaccurately registered, it is possible to remove all registrations at the same All additional controllers in the system must be time.
QUICK GUIDE Technical data General IP20 (IP: degree of inaccessibility to active parts of the product and degree of water) Max. ambient RH (relative humidity) 85% at 20 °C Thermostat CE marking ERP (thermostat only) Low voltage tests EN 60730-1* and EN 60730-2-9*** EMC (electromagnetic compatibility requirements) tests EN 60730-1 Power supply...
Page 10
Uponor Corporation www.uponor.com Uponor reserves the right to make changes, without prior notification, to the specification of incorporated components in line with its policy of continuous improvement and development.
Need help?
Do you have a question about the Smatrix Base PRO and is the answer not in the manual?
Questions and answers