Uponor Smatrix Move PRO Installation And Operation Manual page 47

Change lock code
The standard lock code which is used to block a user
from changing parameter settings, can be changed in
this menu.
This menu is only shown when Lock code has been
enabled in the Lock code menu.
N O T E !
If the controller display is already locked, it
has to be unlocked before entering the new
lock code.
To change the lock code:
1. Select Change lock code.
2. Press the navigation wheel to confirm selection.
3. Enter the new lock code in the boxes using the
navigation wheel.
Turn the navigation wheel to either select a box, or
to increase/decrease a value in edit mode.
Press the navigation wheel to enter edit mode or to
confirm the new setting.
Default: 0000
4. Confirm the new lock code by pressing and holding
the navigation wheel for about 8 seconds.
Display settings
This menu enables display settings, such as contrast,
and it also shows the version number of the display
software.
To set the display contrast:
1. Select Display settings.
2. Press the navigation wheel to confirm selection.
3. Select Display contrast.
4. Press the navigation wheel to confirm selection.
5. Set the display contrast.
Setting range: -50 – 100 %, 1 % increments
6. Press the navigation wheel to confirm selection.
U P O N O R S M AT R I X M O V E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
Restore factory settings
This menu enables all parameter settings in the
controller to be reset to the factory default settings.
To restore the factory settings:
1. Select Restore factory settings.
2. Press the navigation wheel to confirm selection.
3. Select Yes.
Setting range: No (default)/Yes
4. Press the navigation wheel to confirm selection.
5. All parameters in the controller are being restored to
factory settings.
Restore backup
This menu enables the controller to restore all parameter
settings from a previously created backup located on
the microSD-card.
To restore from a backup:
1. Make sure the microSD-card with the backup is
inserted into the controller.
2. Select Restore backup.
3. Press the navigation wheel to confirm selection.
4. Select Yes.
Setting range: No (default)/Yes
5. Press the navigation wheel to confirm selection.
6. All parameters in the controller are being restored
from backup.
EN
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
4 7