Uponor Smatrix Move PRO Installation And Operation Manual page 18

EN
s
uPPly sensor
The supply sensor needs to be installed in all zones.
CZ
Connect supply sensor to controller
The illustration below shows supply sensors connected
DE
to the controller.
1 2 3
DK
EE
#
ES
1 3 5
FI
X-159
FR
To connect a supply sensor to the controller:
1. Study the wiring diagram to locate the connection
terminal positions.
HR
2. Ensure that the power is disconnected from the
controller.
HU
3. Remove the terminal cover.
See section 5.6 Terminal cover for more information.
IT
4. Connect the wires from the supply sensor to the
controller.
• ZONE 1: Terminals 1 and 1 .
LT
• ZONE 2: Terminals 3 and 3 .
• ZONE 3: Terminals 5 and 5 .
LV
• ZONE 4: Terminals 10 and 10 .
5. Tighten the screws fixing the wires to the connector.
NL
NO
PL
PT
RO
RU
SE
SK
1 8
4 S-152
10
r
eturn sensor
The return sensor only needs to be installed in zones
setup as Meltaway or DHW (domestic hot water).
Connect return sensor to controller
The illustration below shows return sensors connected
to the controller.
#
X-159
To connect a return sensor to the controller:
1. Study the wiring diagram to locate the connection
terminal positions.
2. Ensure that the power is disconnected from the
controller.
3. Remove the terminal cover.
See section 5.6 Terminal cover for more information.
4. Connect the wires from the return sensor to the
controller.
• ZONE 2: Terminals 4 and 4 .
• ZONE 3: Terminals 6 and 6 .
• ZONE 4: Terminals 11 and 11 .
5. Tighten the screws fixing the wires to the connector.
U P O N O R S M AT R I X M O V E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
2 3 4 S-152
4 6 11