Troubleshooting After Installation; Contact The Installer; Installer Instructions - Uponor Smatrix Move PRO Installation And Operation Manual

EN
9.1

Troubleshooting after installation

CZ
Problem
The system does
not start
DE
DK
EE
The sensors are
faulty
ES
9.2

Contact the installer

For installer contact information, see the installation
FI
report in the end of this document. Prepare the
following information before contacting an installer:
• Installation report
FR
• Drawings of the underfloor heating system (if
available)
HR
• List of all alarms, including time and date
9.3

Installer instructions

HU
To determine if a problem is caused by the supply
system or the control system, loosen the actuators
IT from the manifold for the room concerned, wait a few
minutes and check if the flow pipe of the underfloor
heating loop becomes warm.
LT
If the pipe does not become warm, the problem is in the
heating system. If the loop becomes warm, the cause
could be the room control system.
LV
A supply system defect can be indicated by no warm
water in the manifold. Check the boiler and circulation
pump.
NL
NO
PL
PT
RO
RU
SE
SK
1 1 8
Indication
The controller display is off
There is 230 V AC power in the wall socket
The controller display continue flashing
and an alarm is displayed
Probable cause
There is no AC power to the controller
Blown controller fuse or faulty power
cable
The cable is not connected or a wire
is damaged
U P O N O R S M AT R I X M O V E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
Solutions
1. Check that the controller is connected
to AC power
2. Check the wiring
3. Check that there is 230 V AC power in
the wall socket
1. Replace the fuse and/or power cable
and plug
Check the wiring