Uponor Smatrix Move PRO Installation And Operation Manual page 44

EN
Return temperature
The current return temperature is shown.
CZ
This information is only shown if Zone Setup is set to
Meltaway.
DE
Ground Temperature
The current temperature in the ground around the snow
DK
sensor is shown.
This information is only shown if Zone Setup is set to
EE
Meltaway.
Ground Moisture
ES
This parameter shows if there is moisture around the
snow sensor.
FI
Primary Return temperature
The current primary return temperature is shown.
FR
This information is only shown if Zone Setup is set to
Meltaway.
HR
Status
This parameter shows the current meltaway status.
HU
Stop: Meltaway is inactive.
Idle: Meltaway is idle and the supply temperature is
kept low to keep the zone from getting too cold.
IT
Melting: Meltaway is active.
Protection: Protecting the heat source from low return
LT
temperatures.
The status may change, in case of sensor fault. An alarm
LV
will also be shown in the display if that is the case.
This information is only shown if Zone Setup is set to
Meltaway.
NL
Mixing Valve
NO The status of the mixing valve is shown. 0 % (supply
from heat source closed) – 100 % (supply from heat
source fully opened).
PL
Pump
The status of the circulation pump is shown (on/off).
PT
This information is only shown if Zone Setup is set to
Stand Alone Control or Meltaway.
RO
RU
SE
SK
4 4
C
ontroller
This menu shows information about the controller.
Menu tree
Controller Information
Language
This menu show the set display language for the
controller.
About...
This menu shows the serial number, software versions,
and hardware versions of the controller.
U P O N O R S M AT R I X M O V E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N U A L
i
nformation
Language
About...