9I-12 Sun Roof / T-Top / Convertible Top:
Step
1. Disconnect the sunroof switch from the harness
connector.
2. Measure the voltage of the sunroof switch express
4
signal circuit of the sunroof switch harness
connector to ground.
Does the voltage measure near the specified value?
Test the sunroof switch express signal circuit for an
open or high resistance. Refer to "Circuit Testing: " and
5
"Wiring Repairs: ".
Did you find and correct the condition?
Inspect the sunroof switch express signal circuit for a
poor connection at the sunroof module. Refer to
6
"Testing for Intermittent Conditions and Poor
Connections: " and "Connector Repairs: ".
Did you find and correct the condition?
Inspect for a poor connection at the sunroof switch.
Refer to"Testing for Intermittent Conditions and Poor
7
Connections: " and "Connector Repairs: ".
Did you find and correct the condition?
Replace the sunroof switch. Refer to "Sunroof Switch
8
Replacement".
Did you complete the replacement?
Replace the sunroof module. Refer to "Control Module
References: " for replacement, setup, and
9
programming.
Did you complete the replacement?
1. Remove any jumper wires.
2. Reconnect all previously disconnected components.
3. Replace sunroof fuse, if necessary.
10
4. Turn ON the ignition, with the engine OFF.
5. Operate the system in order to verify the repair.
Did you correct the condition?
Power Sunroof Does Not Close
Test Description
The number below refers to the step number on the diagnostic table.
2.
If the system does close properly, then suspect either the sunroof limit switch soft stop signal circuit or the sunroof limit
switch low reference circuit for a poor connection or intermittent.
Step
Schematic Reference:"Sunroof Schematics"
Connector End View Reference:"Sunroof Connector End Views"
DEFINITION: Sunroof does not automatically stop in the flush closed position.
Did you perform the Diagnostic System Check -
Vehicle?
1
Operate the power sunroof to the close position.
Does the system close properly?
2
Action
Action
Value(s)
Yes
4.6-5.2 V
Go to Step 5
—
Go to Step 10
—
Go to Step 10
—
Go to Step 10
—
Go to Step 10
—
Go to Step 10
—
System OK
Value(s)
Yes
—
Go to Step 2
Go to "Testing for
Intermittent
—
Conditions and
Poor
Connections: "
No
Go to Step 9
Go to Step 6
Go to Step 9
Go to Step 8
—
—
Go to Step 2
No
Go to
"Diagnostic
System Check -
Vehicle
Diagnostic
Information: "
Go to Step 3