Cruise Release Switch Replacement - Suzuki XL7 2007 Service Manual

– Position the switch into the retainer with the
electrical connector index notch pointing to the 1
o'clock position.
– Slide the switch in the retainer until the plunger is
fully depressed into the barrel.
– Rotate the switch clockwise until the travel stop
has been reached, approximately 60 degrees.
– Inspect the cruise brake switch to ensure the
switch is properly locked into the switch retainer
with the cruise brake switch electrical connector
index notch pointing to the 3 o'clock position.
6. Connect the cruise brake switch harness connector.
7. Install the knee bolster. Refer to "Knee Bolster
Replacement: ".
8. Install the instrument panel left lower closeout panel.
Refer to "Instrument Panel Insulator Panel
Replacement - Left Side: ".
9. Use the scan tool to monitor CRUISE BRAKE
SWITCH in the engine control module (ECM)
General Information data table, while depressing
and releasing the brake pedal. Verify the APPLIED
and RELEASED states read correctly.
Cruise Control System:

Cruise Release Switch Replacement

Removal Procedure
1. Remove the instrument panel left lower closeout
panel. Refer to "Instrument Panel Insulator Panel
Replacement - Left Side: ".
2. Remove the knee bolster. Refer to "Knee Bolster
Replacement: ".
3. Disconnect the cruise brake switch connector.
4. Rotate the cruise brake switch counterclockwise and
remove the cruise brake switch from the switch
retainer.
NOTE
Depressing the brake pedal will allow easier
access of the retainer locking tabs.
5. Gently compress the locking tabs on the cruise
brake retainer and remove the switch retainer from
the brake pedal assembly.
10A-17