Resistance Spot Welded Full Panel Replacement - Suzuki XL7 2007 Service Manual

Hide thumbs Also See for XL7 2007:

Table of Contents

Resistance Spot Welded Full Panel

Use this procedure for all panels that are

replaced at the factory seams, unless a

specific procedure exists in the Collision

Repair section of this vehicle's service

information.

Removal Procedure

Refer to "Approved Equipment for Collision

Repair Caution: ".

1. Disable the SIR system. Refer to "SIR Disabling and

Enabling: ".

2. Disconnect the negative battery cable. Refer to

"Battery Negative Cable Disconnection and

Connection: ".

3. Remove all related panels and components.

4. Repair as much of the damage as possible to factory

specifications.

Refer to "Foam Sound Deadeners Caution: ".

5. Note the location and remove the sealers and anti-

corrosion materials from the repair area, as

necessary. Refer to "Anti-Corrosion Treatment and

Do not damage any inner panels or

reinforcements.

6. Locate and drill out all factory welds. Note the

number and location of the welds for installation of

the service part.

7. Remove the damaged part.

Body Structure:

Troubleshooting