Liftgate Emblem And Nameplate Replacement - Suzuki XL7 2007 Service Manual

9M-15 Exterior Body Panels:
Callout
Preliminary Procedure
Open either the LF or RF door and the hood in order to access the molding assembly screws.
Windshield Frame Filler Panel Applique Screws (Qty: 6)
Tip: One filler panel screw resides under the hood, open the hood in order to access the last filler
panel screw.
CAUTION
!
1
Refer to "Fastener Notice: ".
Tightening torque
Tighten to 1.9 N⋅m (17 lb in)
Windshield Frame Filler Panel Applique Retainers (Qty: 11)
2
Tip: Release the integral retainers from the A-pillar.
3 Windshield Frame Filler Panel Applique Nuts (Qty: 5)

Liftgate Emblem and Nameplate Replacement

Callout
Liftgate Name Plate Assembly (Suzuki)
Tip:
• When removing protective liners from adhesive tape, be careful not to touch tape with hands and
1
do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
• Use a J 25070 or equivalent to remove old nameplate. Clean all adhesive from rear liftgate, wipe
surface dry with a clean lint-free towel prior to installing new nameplate.
Liftgate Nameplate Assembly (XL7)
Tip:
• When removing protective liners from adhesive tape, be careful not to touch tape with hands and
2
do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
• Use a J 25070 or equivalent to remove old emblem. Clean all adhesive from rear liftgate, wipe
surface dry with a clean lint-free towel prior to installing new emblem.
Liftgate Name Plate Assembly (AWD)
Tip:
• When removing protective liners from adhesive tape, be careful not to touch tape with hands and
3
do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
• Use a J 25070 or equivalent to remove old nameplate. Clean all adhesive from rear compartment
lid, wipe surface dry with a clean lint-free towel prior to installing new nameplate.
Component Name
Component Name