Suzuki XL7 2007 Service Manual page 3076

10A-18 Cruise Control System:
Installation Procedure
NOTE
Ensure that the indexing arrow is facing to
the right and the ears on the retainer are fully
extended on the back side of the bracket to
prevent the retainer from being pushed out.
1. Install the cruise brake switch retainer into the upper
hole of the brake pedal assembly with the retainer
arrow pointing in the 3 o'clock position.
NOTE
Do not depress the brake pedal assembly
during the cruise brake switch installation.
Depressing the brake pedal during the cruise
brake switch installation will cause a brake
drag condition.
2. Install the cruise brake switch.
– Position the switch into the retainer with the
electrical connector index notch pointing to the 1
o'clock position.
– Slide the switch in the retainer until the plunger is
fully depressed into the barrel.
– Rotate the switch clockwise until the travel stop
has been reached, approximately 60 degrees.
– Inspect the cruise brake switch to ensure the
switch is properly locked into the switch retainer
with the cruise brake switch electrical connector
index notch pointing to the 3 o'clock position.
3. Connect the cruise brake switch harness connector.
4. Install the knee bolster. Refer to "Knee Bolster
Replacement: ".
5. Install the instrument panel left lower closeout panel.
Refer to "Instrument Panel Insulator Panel
Replacement - Left Side: ".
6. Use the scan tool to monitor CRUISE BRAKE
SWITCH in the engine control module (ECM)
General Information data table, while depressing
and releasing the brake pedal. Verify the APPLIED
and RELEASED states read correctly.