Audio Distortion - One Or More Speakers; Radio Setup; Digital Radio Receiver Setup - Suzuki XL7 2007 Service Manual

5. After the top disc is removed, push the "Eject" button
again to remove the bottom disc.
6. Check the operation of the radio to see if a CD or
DVD can be inserted and then ejected. If a CD or
DVD can be inserted and ejected from the radio,
then reinstall the radio into the Instrument Panel. If a
CD or DVD cannot be inserted and then ejected from
the radio, send the radio to your authorized
Electronic Service Center for repair.

Audio Distortion - One or More Speakers

Diagnostic Fault Information
Perform the "Diagnostic System Check - Vehicle
Diagnostic Information: " prior to using this diagnostic
procedure.
Reference Information
Schematic Reference
"Radio/Navigation System Schematics"
Connector End View Reference
"Entertainment/Communication Connector End Views"
Electrical Information Reference
• "Circuit Testing: "
• "Connector Repairs: "
• "Testing for Intermittent Conditions and Poor
Connections: "
• "Wiring Repairs: "
Scan Tool Reference
"Scan Tool Data List - Cellular, Entertainment, and
Navigation"
Special tool
J 39916-A CD Diagnostic Audio Kit
Circuit/System Testing
Without Amplifier
1. Turn ON the ignition, with the engine OFF, and turn
ON the radio. Adjust the fade and balance controls
to mid range and insert the CD from the J 39916-A to
identify the suspect speaker.
➢ Replace suspect speaker if distortion is found.
With Amplifier
1. Turn ON the ignition, with the engine OFF, and turn
ON the radio. Adjust the fade and balance controls
to mid range and insert the CD from the J 39916-A to
identify the suspect speaker.
2. Disconnect the suspect speaker harness connector.
3. Ignition ON, test for greater than 9 volts on the
suspect (+) audio output signal circuit and ground.
➢ If all circuits test normal, replace suspect speaker if
distortion is found.
Cellular / Entertainment / Navigation / Audio:
Repair Instructions
Perform the "Diagnostic Repair Verification - Vehicle
Diagnostic Information: " after completing the diagnostic
procedure.
"Speaker Replacement Reference"

Radio Setup

Without U3U
1. To setup a new radio for the vehicle, complete the
Module Setup procedure under the Special
Functions menu of the scan tool.
2. Cycle ignition with the retained accessory power
(RAP) disabled, when complete
With U3U (Navigation Radio)
1. Radio setup completed using the Service
Programming System (SPS). Refer to "Service
Programming System (SPS): ".
2. Cycle ignition, with the retained accessory power
(RAP) disabled, when complete.

Digital Radio Receiver Setup

XM Activation
NOTE
After replacement of an XM receiver, call XM
radio to deactivate the receiver that has been
removed from the vehicle. The vehicle must
be parked in view of a satellite within 24
hours after an activation call.
1. Turn the radio ON, tune to the XM channel 0, and
record the radio ID. The radio ID will be needed for
activation of the new receiver.
2. Call XM radio at 1-800-556-3600 to deactivate the
faulty receiver and activate the new receiver.
3. Park the vehicle outside in an area with an
unobstructed view of the southern sky.
4. Leave the vehicle outside with the ignition switch in
the ACC position and the radio on for 30 minutes to
activate XM service.
5. Once activated, the radio will receive the remaining
XM channels.
9O-46