Table of Contents
Advertisement
Calibration on E3G080
5
Calibration on E3G080
5.1
Line voltages E3G080
5.2
Automatic calibration
Building Technologies
Fire Safety
Each output and each input is controlled and set accordingly. In doing so, the re-
lays for the valve actuation are blocked by both the hardware and software; the
valves can no longer be activated. The illuminated warning panel and the horn are
blocked by the software only. Before initiating the automatic calibration, the tension
at the terminals must be checked. All switches must be in "Rest" position (see the
following table).
from the device version 06
-> Details see document 001260
System power up
1. Press 'S4' key once (service switch 'S1' must be in position ON)
Situation A:
When all in-/outputs are in order, or when there is no change to the configura-
tion, or when the monitoring has been deactivated, all LEDs 'H1'...'H4' are
flashing simultaneously during approx. 5 seconds; afterwards the deactivated
control lines are briefly displayed in sequence in short time intervals (see ta-
ble below). The initialisation (calibration) is completed; proceed to step 5.
Situation B:
When in /outputs are faulty, or when the configuration has been changed, the
LEDs 'H1'/'H3' and 'H2'/'H4' are flashing alternately during approx. 5 se-
conds, then the faulty and deactivated control lines are briefly displayed in
sequence in short time intervals (see table below).
2. Remedy fault and/or change configuration
3. Press service key 'S4' once to read in the new situation
the LEDs react in accordance with situation B
4. Press service key 'S4' once to acknowledge the new situation
the LEDs react in accordance with situation A
5. Set service switch 'S1' to OFF
The extinguishing activation is ready for operation.
13
009853_b_en_--
01.2013
Advertisement
Table of Contents
