Emerson Daniel 3410 Series Operation Manual page 50

Configurations
January 2019
Table 5-5: Configure Operational parameters
Calibration selection
Flow calibration
calibration)
Frequency/Digital output
sources
Frequency/Digital output
sources)
Frequency output
(Configure frequency
outputs)
Meter Digital outputs
(Configure digital input/
outputs)
HART outputs
HART
Meter corrections
(Configure meter
corrections)
Temperature and pressure
(Configure temperature
and pressure)
Gas Chromatograph setup
(Configure Gas
Chromatograph
parameters)
AGA8 calculations
(Configure AGA8
parameters)
50
Description
(Flow Calibrate the meter during flowing conditions.
Outputs that can be configured as either a frequency output or a
(Configure digital status.
Configure the available frequency outputs.
Configure the digital outputs.
(Configure Configure the HART outputs.
outputs)
Configure meter corrections that include:
• Temperature expansion correction (if Live or Fixed), Linear
expansion coefficient
• Linear expansion coefficient reference temperature
• Pressure expansion correction
• Pipe outside diameter
• Young's modulus value (ratio of tensile stress to tensile strain)
• Poisson's Ratio value (the absolute ratio of the pipe material lateral
strain over axial strain)
Temperature and Pressure - to set the scaling for analog inputs, enter
fixed values, and set alarm limits for both temperature
Configure a serial port as a Modbus master for polling a GC. Selections
include:
• Serial port
• GC protocol
• GC baud rate
• GC comms address
• GC stream number
• GC heating value units
Configure the properties necessary for the AGA8 calculations.
Selections include:
• Gross Method 1
• Gross Method 2
• Detail
• Externally
Operations manual
(continued)
DAN-20057316
Operations manual