Emerson Daniel 3410 Series Operation Manual page 132

Commands
January 2019
Figure 7-9: Program download dialog
Procedure
1. Click Open to display an Open Download File dialog and select the desired file and
2. Daniel MeterLink
3. Click Download to initiate the download process. Daniel MeterLink
4. The meter will have to restart to install the firmware. Daniel MeterLink
132
click Open.
The filename displays in the File edit box under Upgrade. The Version and Date of
the components to download display in the table under Upgrade. All of the
components will be identified as if they are older, newer, or the same as what is
currently installed in the meter.
™
only downloads components that are different than what is
currently installed in the meter. At least one component must be different for
download before the Download button is enabled.
configuration from the meter and displays a message where it was saved. If the
upgrade requires the database to be reset, then it will be necessary to use the Edit/
Compare Configuration dialog to write this configuration back down to the meter
after the program download is complete
After the configuration is saved, a progress bar will appear showing the status of the
file download. After the files have been transferred successfully to the meter, the
meter will start the upgrade process and the status will be shown down below
Upgrade Progress.
you with a message that it must disconnect from the meter. Once the firmware
Operations manual
(Edit/Compare configuration
DAN-20057316
™
collects the
parameters).
™
will prompt
Operations manual