Table of Contents
Advertisement
ECDIS User Guide
Transmit Mode
In addition to the functions listed in Standby mode, the
following functions are available when the ECDIS chart display
is in Transmit mode:
•
Radar Video
•
Display and selection of target data
•
Video Processing Controls, see `Video' in Chapter 12 Radar
•
Radar Fine Tuning, see `Transceiver' in Chapter 12 Radar
If you are not familiar with using the ECDIS display, it is strongly
recommended that you read System Controls. This describes how to use
the external controls in order to operate the system.
Standby/Transmit Mode in Dual Radar
In a dual radar system the transceivers for channel 1 and
channel 2 may be individually switched between Standby and
Transmit.
For information on Standby and Transmit mode and video control for a
Dual Channel Radar, refer to `Dual Radar – Transmit and Video Mode
Selection' in Chapter 3 `Basic Operation of ECDIS'.
2-21
Basic Operation of ECDIS
65900012
Advertisement
Table of Contents
Need help?
Do you have a question about the Visionmaster FT ECDIS and is the answer not in the manual?