Table of Contents
Advertisement
ECDIS User Guide
Alert Type
Dual Homing Config
Conflict detected in VMFT configuration of Dual Homing and actual
Error
setup.
Dual Homing Fault
No connection on one or more of the network adapters.
Dynamic Licensing
Dynamic Licensing has been disabled because there are no chart
Insufficient Credits
credits remaining.
Dynamic Licensing
Dynamic Licensing has a low number of chart credits remaining.
Low Credits
Dynamic Licensing
Dynamic Licensing has been disabled because the Dynamic
Report Expired
Licensing report is past due.
Dynamic Licensing
The Dynamic Licensing report is almost due. Charts must be
Report Near Due
reported by {0}.
Early Course Change
Early course change alert issued based on wheel-over TTG.
Early Course Change
Early course change alert issued based on wheel-over TTG. The
operator messages will be inhibited until this alert is acknowledged.
Engine Mass Based
Sensor Engine Mass Based Fuel Consumption Rate Value Integrity
Fuel Consumption
VisionMaster FT
Rate Unusable
Engine Power Value
Sensor Engine Power Value Integrity VisionMaster FT
Unusable
Engine Propulsion
Sensor Engine Propulsion Power Integrity VisionMaster FT
Power Unusable
Engine RPM Unusable
Sensor Engine RPM Integrity VisionMaster FT
Engine Speed Value
Sensor Engine Speed Integrity VisionMaster FT
Unusable
65900012
Description
Alerts
Priority
Notes
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Alarm
Alarm or
Depending on
Caution
configuration
Alarm or
Depending on
Caution
configuration
Alarm or
Depending on
Caution
configuration
Alarm or
Depending on
Caution
configuration
Alarm or
Depending on
Caution
configuration
7-21
Advertisement
Table of Contents
Need help?
Do you have a question about the Visionmaster FT ECDIS and is the answer not in the manual?
Questions and answers
HI THERE , I COULD NOT FIND THE MOB BUTTON IN THE UPPER TOOLBAR AND IN NAV TOOLS , AND THE VIDEO PLAYBACK BUTTON ON IUR SPERRY MARINWE ECDIS.
The MOB (Man Overboard) button can be found in the upper toolbar of the Sperry Marine VisionMaster FT ECDIS. It has a yellow background when the MOB event is active and a standard background color when inactive. However, there is no information provided in the context regarding the location of a video playback button.
This answer is automatically generated
WHAT IS THE PROCEDURES IN MAKING PARALLEL INDEX USING SPERRY MARINE ECDIS
To make a Parallel Index (PI) using Sperry Marine Visionmaster FT ECDIS, follow these procedures:
1. Access PI Lines: Left-click on the "Parallel Index Lines" field in the NAV Tools menu.
2. Use the PI Lines Window: This window has three tabs:
- Edit Tab: Add a new PI line or set, copy, delete, rename, or realign lines to the ship's current heading.
- Display Tab: Select which PI lines to display.
3. Define Each PI Line: Set the following parameters:
- Range from the closest point to own ship
- Bearing
- Line type
- Side of the ship (port or starboard)
Up to fifteen PI lines can be displayed at once across the entire chart display in all modes.
This answer is automatically generated
AIS target not showing in ecdis