Table of Contents
Advertisement
ECDIS User Guide
Warnings and Cautions
The features, functionality and capability which are described in this
manual are not necessarily present in all versions or configurations of the
VisionMaster FT system.
WHEN ACCESS COVERS ARE REMOVED, LETHAL VOLTAGES MAY BE
EXPOSED. SOME CAPACITORS USED IN THE EQUIPMENT TAKE
SEVERAL MINUTES TO DISCHARGE THEIR STORED VOLTAGES AFTER
SWITCH OFF; THIS IS A LETHAL VOLTAGE HAZARD. ALWAYS SET THE
SUPPLY SWITCH-FUSE TO OFF AND REMOVE THE FUSES, BEFORE
REMOVING THE ACCESS COVERS OF THE EQUIPMENT.
WHEN CLEANING THE INSIDE OF THE EQUIPMENT, TAKE CARE NOT
TO INHALE DUST. THE DUST IS A TEMPORARY HEALTH HAZARD,
DEPENDING ON INDIVIDUAL ALLERGIES.
KEEP OUTSIDE THE HAZARD ZONE AROUND AN ANTENNA OR OPEN
WAVEGUIDE RADIATING POWER. REFER TO THE TABLE BELOW FOR
HAZARD ZONES. WHEN IT IS NECESSARY TO WORK ON THE SCANNER
UNIT, MAKE SURE THAT RADAR IS SWITCHED OFF, AND THAT BOTH
THE MAINS ISOLATOR AND THE SCANNER CONTROL UNIT ARE
TURNED TO THE OFF POSITION.
NEVER LOOK DIRECTLY INTO AN OPEN WAVEGUIDE.
RADAR AND OTHER FORMS OF RF RADIATION CAN CAUSE CARDIAC
PACEMAKERS TO MALFUNCTION. IF YOU USE A CARDIAC
PACEMAKER AND SUSPECT A MALFUNCTION, LEAVE THE VICINITY OF
THE RADAR SYSTEM IMMEDIATELY AND SEEK MEDICAL ADVICE.
Most countries accept that there is no significant radiation hazard at RF
power density levels of up to 100W/m
65900012
WARNING: Lethal Voltage Hazard
WARNING: Health Hazard
WARNING: Radiation Hazard
2
2
(10mW/cm
).
Warnings and Cautions
iii
Advertisement
Table of Contents
Need help?
Do you have a question about the Visionmaster FT ECDIS and is the answer not in the manual?
Questions and answers
HI THERE , I COULD NOT FIND THE MOB BUTTON IN THE UPPER TOOLBAR AND IN NAV TOOLS , AND THE VIDEO PLAYBACK BUTTON ON IUR SPERRY MARINWE ECDIS.
The MOB (Man Overboard) button can be found in the upper toolbar of the Sperry Marine VisionMaster FT ECDIS. It has a yellow background when the MOB event is active and a standard background color when inactive. However, there is no information provided in the context regarding the location of a video playback button.
This answer is automatically generated
WHAT IS THE PROCEDURES IN MAKING PARALLEL INDEX USING SPERRY MARINE ECDIS
To make a Parallel Index (PI) using Sperry Marine Visionmaster FT ECDIS, follow these procedures:
1. Access PI Lines: Left-click on the "Parallel Index Lines" field in the NAV Tools menu.
2. Use the PI Lines Window: This window has three tabs:
- Edit Tab: Add a new PI line or set, copy, delete, rename, or realign lines to the ship's current heading.
- Display Tab: Select which PI lines to display.
3. Define Each PI Line: Set the following parameters:
- Range from the closest point to own ship
- Bearing
- Line type
- Side of the ship (port or starboard)
Up to fifteen PI lines can be displayed at once across the entire chart display in all modes.
This answer is automatically generated
AIS target not showing in ecdis