Table of Contents
Advertisement
ECDIS User Guide
AIS Display
The AIS Display window includes:
•
Settings All Nodes
•
Filter Settings
•
Other
•
Target Count All Nodes
This may be quickly accessed from the main
screen by left clicking on the AIS button on the
upper toolbar.
Settings All Nodes
AIS Input
AIS input and the display of AIS targets is
turned on or off on all nodes by ticking the
Enable Input check box.
AIS Input can only be enabled when
valid sensor data is being transmitted.
Activate on CPA/TCPA/BCR
When this check box is enabled (default mode)
a sleeping AIS target is automatically activated
when the target infringes its CPA/TCPA or BCR
limits shown in the Target Data tab folder.
If this setting is disabled all sleeping AIS targets
are rendered as dotted lines (see `AIS
Rendering Conditions' in AIS Targets) and not
activated when target data limits are infringed.
THIS SETTING SHOULD NORMALLY BE ENABLED.
DISABLING AUTO-ACTIVATION FOR COLLISION AVOIDANCE MAY
RESULT IN POTENTIALLY DANGEROUS TARGETS NOT RAISING
AN ALERT
65900012
WARNING!
Targets
10-29
Advertisement
Table of Contents
Need help?
Do you have a question about the Visionmaster FT ECDIS and is the answer not in the manual?
Questions and answers
HI THERE , I COULD NOT FIND THE MOB BUTTON IN THE UPPER TOOLBAR AND IN NAV TOOLS , AND THE VIDEO PLAYBACK BUTTON ON IUR SPERRY MARINWE ECDIS.
The MOB (Man Overboard) button can be found in the upper toolbar of the Sperry Marine VisionMaster FT ECDIS. It has a yellow background when the MOB event is active and a standard background color when inactive. However, there is no information provided in the context regarding the location of a video playback button.
This answer is automatically generated
WHAT IS THE PROCEDURES IN MAKING PARALLEL INDEX USING SPERRY MARINE ECDIS
To make a Parallel Index (PI) using Sperry Marine Visionmaster FT ECDIS, follow these procedures:
1. Access PI Lines: Left-click on the "Parallel Index Lines" field in the NAV Tools menu.
2. Use the PI Lines Window: This window has three tabs:
- Edit Tab: Add a new PI line or set, copy, delete, rename, or realign lines to the ship's current heading.
- Display Tab: Select which PI lines to display.
3. Define Each PI Line: Set the following parameters:
- Range from the closest point to own ship
- Bearing
- Line type
- Side of the ship (port or starboard)
Up to fifteen PI lines can be displayed at once across the entire chart display in all modes.
This answer is automatically generated
AIS target not showing in ecdis