HID FARGO HDP 6600 X002200 User Manual page 112

Printer Display Error Message
Wrong Ribbon
Error Message No. 520
See Manual
Error Message No. 431, 432, 433, 452,
457, 485, 547, 548, 549, 550
See Manual
Error Message No. 438
Ribbon Temp Error
Error Message No. 441
Please Install Film and Close Cover
Error Message No. 536
Check Film/Card
Error Message No. 552
112
Troubleshooting
Cause
The ribbon installed in the printer
does not match the ribbon type
selected in the printer driver.
OR
A self-test job cannot be printed with
the print media installed.
Unspecified system error is detected
by printer firmware.
The print head has become too hot.
The ambient temperature of the
printer is too high.
OR
Sensor failure.
Film is not installed.
Card became jammed in printer
during transfer.
PLT-02931, Rev. A.0
Solution
Replace the ribbon in the printer with
the type specified by the printer
driver.
Reset printer and try again. If
problem persists, call for technical
assistance.
Allow to cool off and try again.
Allow to cool off and try again. If
problem persists, call for technical
assistance.
Install the film. Press OK and run the
calibration routine again.
Clear the jam.
September 2018