PLT-02931, Rev. A.0
Device Settings
Menu option
Card Flattener
Print Mode
September 2018
Description
This option is available only for single-sided card printing and is grayed out if a card flattener is
not detected. Available options are:
Enabled: Select this option to enable the flattener.
Advanced Settings: This option is grayed out unless the Enabled option is selected. When
selected, the Card Flattener window is displayed.
Temperature (Celsius):
Lower limit: -50
Upper limit: +50
Dwell Time (seconds per inch): Sets the Dwell Time for the flattening process.
Lower limit = 1 second per inch
Upper limit = 3 seconds per inch
Delay (Seconds): Sets the Delay for the flattening process.
Lower limit = 0
Upper limit = 15
Use Defaults Based on Selected Card Type: This option is automatically selected. Clear this
box to set the options in this window.
Note: If you select the wrong option, the incorrect dwell time and temperature may be used in
the flattening process which may result in card warping.
If Flip Card Before Print is selected, the reverse side of the card is printed first.
Note: This option is available only for dual-sided card printing and is grayed out if a dual-sided
module is not detected.
Printing preferences
49