HID FARGO HDP 6600 X002200 User Manual page 110

Printer Display Error Message
Headlift Error
Error Message No. 553, 554, 555, 556
Headlift Error
Error Message No. 560
Job Data Error
Error Message No. 544
Mag Verify Error
Error Message No. 487
Multiple Feed
Error Message No. 475
No E-card Encoder
Error Message No. 451
No Film
Error Message No. 492
No Flip Module
Error Message No. 482
No Mag Module
Error Message No. 486
No Ribbon
Error Message No. 518, 524
See Manual
Error Message No. 444
110
Troubleshooting
Cause
There is a problem with the transfer
roller headlift.
There is a problem with the transfer
roller headlift.
The print data sent to the printer is
corrupt or has been interrupted.
Printer could not verify mag write.
OR
The magnetic stripe was not
encoded properly.
Multiple cards were fed into the
printer.
You are trying to send encoding data,
but the printer is not configured with
this encoder type.
Film is not installed in the printer.
OR
Film RFID tag is bad.
Two-sided job sent to a one-sided
printer.
Mag encoding job sent to the printer
without a mag encoder.
You are trying to send encoding data,
but the printer is not configured with
this encoder type.
No ribbon is installed in the printer.
OR
The ribbon RFID tag is bad.
An error was detected during
printing.
PLT-02931, Rev. A.0
Solution
Reset the printer and try again. If
problem persists, call for technical
assistance.
Reset the printer and try again. If
problem persists, call for technical
assistance.
Reset the printer and try again.
If this problem persists, call for
technical assistance.
Check the cards for correct mag
stripe orientation and try again.
Verify the mag coercivity selection in
the driver matches that of the cards
Remove all cards and try again.
To cancel, press Cancel Print.
Install the film and press Resume.
To cancel the print, press Cancel on
the printer display or click Cancel
Print from the HID Printer Status
Monitor.
Using the printer display, verify the
printer has flipper capabilities.
If flipper capabilities are present,
ensure that the Print Both Sides
option in the printer driver is set
correctly.
Press Resume on the printer display
to continue printing.
To cancel the print, click Cancel Print
from the HID Printer Status Monitor.
To cancel the print, click Cancel Print
from the HID Printer Status Monitor.
Install the correct ribbon and press
Resume on the printer display.
To cancel the print, press Cancel on
the printer display or click Cancel
Print from the HID Printer Status
Monitor.
Reset the printer and try again.
If this problem persists, call for
technical assistance.
September 2018